Failure to understand. Failure to understand and follow the contents of this Keep cord away from heat, oil, sharp edges or moving parts. Read and understand all instructions. Damaged cords increase the risk Failure to follow all instructions listed of electrical shock. Such preventive safety measures or bolt and to power RIDGID roll grooving equip- reduce the risk of starting the tool accidentally.
Follow instructions on proper use of this machine. The machine is designed to mount on the three uni- versal stands listed below. The No. Clean the speed chuck jaws with a wire brush. Inspect the jaw inserts for excessive wear. Refer to the Maintenance Instructions if they need to be replaced. If such conditions Cutting Oil. Forward position. Tighten the rear centering device around the pipe by 7. Install die set. Refer to Die Installation procedure. Swing cutter and reamer to UP position.
Figures 11 See Figure To remove die head part way through a thread, Only The Nos. Reinstall die head washer and tighten size adjusting nut. Only Pipe Pipe The Nos. To make cut-off without getting oil inside mate- rial, proceed with following steps: A Position oil coolant spout down just far enough to direct a small amount of oil on rear roll.
Adjust die head to proper size. Release Lever Lockout Plate 5. Fully loosen feed screw assembly so that dies do not contact O. With pipe securely tightened in front chuck, turn car- riage handwheel counter-clockwise to bring die head stop against end of pipe. Note: All Dimensions are in Inches. DEPTH 1. Figure 25 Standard Size Thread — Either one of following 2 refer Securely close the machine chuck onto the nipple.
If using Nipple Chuck with the A or threading. If needed, remove the thread adapter with the wrench. Figure 2 — Installing Nipple Chuck and Insert. Install the proper size pipe adapter and tighten with the.
Screw the threaded end of the nipple into the pipe adapter. If this. Following the instructions for the threading machine used,. Watch closely for any interfer-. Insert the wrench pin into one of the holes on body of the. Turn the wrench to release the finished nip-. See Figure 4. Previous Page. Next Page. With the Adapter kit, the can be used with A and Threading Machines.
The Model is used with Threading Machine. Page 3 , compacta , , y Si es necesario, use la llave para extraer el adaptador de roscado. This manual is also suitable for: Print page 1 Print document 4 pages. Rename the bookmark.
Delete bookmark? Cancel Delete. Delete from my manuals? Sign In OR. Don't have an account?
0コメント