Alsamixer displays an ncurses interface to the various devices within the soundcard. You can select devices using the left and right arrow keys or n and p for n ext and p revious. Level for the selected device can be adjusted with the up and down arrow keys or w and x.
Mute status can be toggled with the m key. Capture status can be toggled with the space bar. All devices were muted the levels set to zero. Then 'Capture' and 'ADC' were unmuted and turned all the way up. Line in port capture works but I am unable to get the Mic in port to capture.
Master, PCM and Wave were unmuted and set to the maximum "green" level. This allows the input to play through the speakers while it is recording.
For each mixer scenario described above you can store the settings in a file and then use that file to set the soundcard:. See the. The Gentoo Linux Distribution also has good help for installing and setting up Alsa on thier website:.
Category : Sound cards. Start alsamixer: alsamixer Prepare the soundcard for recording from the microphone: Alsamixer displays an ncurses interface to the various devices within the soundcard. This package is known to build and work properly using an LFS Note that all channels of your sound card are muted by default. You can use the alsamixer program to change this. Use speaker-test to check that your settings have been applied correctly.
The alsactl program is normally run from a standard udev rule. You can prevent this by running the following command as the root user:. The volume settings should be restored from the saved state by Udev when the device is detected during boot or when plugged in for USB devices. All sound devices are not accessible for any user except root and members of the audio group. Add any users that might use the sound devices to that group:.
You may need to log out and back in again to refresh your group memberships.
0コメント